If you want free power, and following easy, step-by-step instructions is no problem, then it is time to learn how to build your own solar panels.
Click here if you can't wait to learn how to build solar panels and collect the suns rays for free electricity
A solar panel harnesses the suns rays, and converts solar energy into the kind of electricity you can use in your home. Commercially produced solar panels are made from silicon, using very expensive equipment. They are highly efficient, but as a result, they are prohibitively expensive.
Not all solar panels, however, have to be made from silicon. Other materials, such as cuprous oxide, can be used instead. Even though it may be less efficient, cuprous oxide produces the same photoelectric effect as silicon, but it still enables light to cause electricity to flow into the material.
Click here if you can't wait to find out how to build solar panels and harness free energy
If you consider the trade off against efficiency, the amount of money you can save by building solar panels at home is huge and make it well worth taking the DIY route. A quick visit to the hardware store or Ebay and, you will be harnessing your own solar power in no time. An 8" x 24" panel should supply enough power to run small domestic appliances and lights. Keep making more panels until your home power station is producing enough for the whole house and then relax and never pay another power bill again. Start with one, and keep going, it's a simple process to repeat over and over. Learning to build a solar panel is fairly easy and there are plenty of DIY kits available with easy-to-follow, step-by-step instructions.
You will also need storage batteries so that you don't waste any surplus power, and you have reserves for later, say at night when there is no sun. If you plan on powering your whole house with free energy, you will need a deep cycle battery for continuous use. At around $50, they are fairly cheap.
The materials needed for the panels are fairly easy to find: You'll need a sheet of copper flashing, found easily at most suburban hardware stores, as are alligator clips and LCD multimeters, you will also need sand paper, or a wire brush and sheet metal shears. All other materials can be found at home: an electric stove, table salt, a plastic bottle and water. All that's missing now is a set of DIY instructions.
Click here if you never want to pay another power bill again.
Other articles you might like;



US $84.99




Leave a Reply